Traction

Overview :

Skin traction

Skin traction uses five-to seven-pound weights attached to the skin to indirectly apply the necessary pulling force on the bone. If traction is temporary, or if only a light or discontinuous force is needed, then skin traction is the preferred treatment. Because the procedure is not invasive, it is usually performed in a hospital bed.

Weights are attached either through adhesive or nonadhesive tape, or with straps, boots, or cuffs. Care must be taken to keep the straps or tape loose enough to prevent swelling and allow good circulation to the part of the limb beyond the spot where the traction is applied. The amount of weight that can be applied through skin traction is limited because excessive weight will irritate the skin and cause it to slough off.

Specialized forms of skin traction have been developed to address specific problems. Dunlop's traction is used on children with certain fractures of the upper arm, when the arm must be kept in a flexed position to prevent problems with the circulation and nerves around the elbow. Pelvic traction is applied to the lower spine, with a belt around the waist. Buck's skin traction is used to treat knee injuries other than fractures. The purpose of this traction is to stabilize the knee and reduce muscle spasm.

Skeletal traction

Skeletal traction is performed when more pulling force is needed than can be withstood by skin traction; or when the part of the body needing traction is positioned so that skin traction is impossible. Skeletal traction uses weights of 25-40 pounds.

Skeletal traction requires the placement of tongs, pins, or screws into the bone so that the weight is applied directly to the bone. This is an invasive procedure that is done in an operating room under general, regional, or local anesthesia.

Correct placement of the pins is essential to the success of the traction. The pin can be kept in place several months, and must be kept clean to prevent infection. Once the hardware is in place, pulleys and weights are attached to wires to provide the proper pull and alignment on the affected part.

Specialized forms of skeletal traction include cervical traction used for fractures of the neck vertebrae; overhead arm traction used for certain types of upper arm fractures; and tibia pin traction used for some fractures of the femur, hip, or pelvis.